Screen: 12864 resolution, LCD back light. Frequency: 2.4GHz ISM band (2400MHz-2483.5MHz). Battery compartments: 259760mm (JST 2Pin connector).Size: 22.417.511.6cm. Radiolink RC6GS V2 transmitter x 1. Radiolink R7FG Receiver x 1. Radiolink R6FG Receiver x 1. Radiolink R4FGM Receiver x 1. Control Distance: Over than 600 meers. Signal output: PPM/PWM/S-BUS, 2.4GHz.
Size: 126.96.36.199cm. RC6GS V2 RC Remote Control Transmitter Features. Real pseudo random algorithm FHSS communication technology makes RC6GS V2 control distance up to 1900 feet (600meters), and over 20 units of RC6GS V2 can work simultaneously at one place without any interference.Up to 600m Ground Distance? The control distance is up to 600 meters under the superior anti-interference ability. R7FG built-in gyro can keep the vehicle runs in a straight line, and Gyro sensitivity can be adjusted by transmitter, which fits for drifting and on-road cars. Real-time signal strength, RX battery voltage EXT (Model battery voltage) can be dispalyed on the RC6GS V2 screen. (Only support works with R7FG or R8F). CH3-CH6 can be customized to VR, three-way switch and tact switch, the tact switch can be used for cruise control mode, a good idea for crawler, all channels' fail-safe values can be set to any value as you need. Mix control can be programmed with any two channels and each channel can be customized. That's friendly for twin-engine vehicles, such as tanks, boats, 4 wheel steering car.
Adapts to Most of Types Vehicles? With 10 models storage and each model can be set up and named separately. It is suitable for RC rock crawler, monster truck, Baja, off-road RC car, etc.
The handle shape is more linear and handy with the ergonomic design. The strips on the trigger increase the touching friction. Added Hook, FPV monitor holder hole, middle of the handle SWD switch, user can personalize by changing SWA to SWD. Anti-polarity connect protection technology to keep your transmitter safety even if you Accidentally connect the wrong positive and negative poles.
JST connector supports multiple batteries: liPo or 6AA. Q: What battery is suitable to work with RC6GS V2? What's the voltage range?A: The JST connector of RC6GS V2 can be easily adapted for various batteries including LiPo battery of 2S to 4S and 6pcs of AA batteries. The voltage range is 4.8V to 15V. Check the picture for battery box reference. Q:Why my receiver will not connect to the remote control? A:It means the receiver didn't bind to the transmitter, you can check if there's signal tower on the top of your transmitter screen.
If not, need you bind again. Put the transmitter and receiver about 50 cm apart. Turn on the transmitter power switch first, and then power on the receiver. Q:Does RC6GS V2 have low voltage alarm function to protect my battery?
A:Yes of course, there are 4 kinds of alarms. It can remind you to change the battery. Q:Why the gyro is not working properly, making the servos twitch uncontrollably? A:If the servos twitch uncontrollably after you used the gyro function, it means the sensitivity value of the gyro is too large, you can adjust the value or turn the gyro off.
Radio Link Gyro Transmitter&Receiver+Remote Control&Accessories-Car, RC, Boat, etc? The item "Radio Link Gyro Transmitter&Receiver+Remote Control&Accessories-Car, RC, Boat, etc" is in sale since Sunday, September 19, 2021. This item is in the category "Toys, Hobbies\Radio Control & Control Line\RC Model Vehicle Parts & Accs\Control, Radio & Electronics\Receivers & Transmitters". The seller is "sea-of-shoppers" and is located in Port Melbourne, VIC.This item can be shipped to Australia, all countries in Europe, United States, New Zealand, Canada.